AngoLinux |
80386 Programmer's Reference Manual -- Opcode OUTS |
OUTS/OUTSB/OUTSW/OUTSD -- Output String to Port
Notes*If CPL <= IOPL **If CPL > IOPL or if in virtual 8086 mode OperationIF AddressSize = 16 THEN use SI for source-index; ELSE (* AddressSize = 32 *) use ESI for source-index; FI; IF (PE = 1) AND ((VM = 1) OR (CPL > IOPL)) THEN (* Virtual 8086 mode, or protected mode with CPL > IOPL *) IF NOT I-O-Permission (DEST, width(DEST)) THEN #GP(0); FI; FI; IF byte type of instruction THEN [DX] := [source-index]; (* Write byte at DX I/O address *) IF DF = 0 THEN IncDec := 1 ELSE IncDec := -1; FI; FI; IF OperandSize = 16 THEN [DX] := [source-index]; (* Write word at DX I/O address *) IF DF = 0 THEN IncDec := 2 ELSE IncDec := -2; FI; FI; IF OperandSize = 32 THEN [DX] := [source-index]; (* Write dword at DX I/O address *) IF DF = 0 THEN IncDec := 4 ELSE IncDec := -4; FI; FI; FI; source-index := source-index + IncDec; DescriptionOUTS transfers data from the memory byte, word, or doubleword at the source-index register to the output port addressed by the DX register. If the address-size attribute for this instruction is 16 bits, SI is used for the source-index register; otherwise, the address-size attribute is 32 bits, and ESI is used for the source-index register.OUTS does not allow specification of the port number as an immediate value. The port must be addressed through the DX register value. Load the correct value into DX before executing the OUTS instruction. The address of the source data is determined by the contents of source-index register. Load the correct index value into SI or ESI before executing the OUTS instruction. After the transfer, source-index register is advanced automatically. If the direction flag is 0 (CLD was executed), the source-index register is incremented; if the direction flag is 1 (STD was executed), it is decremented. The amount of the increment or decrement is 1 if a byte is output, 2 if a word is output, or 4 if a doubleword is output. OUTSB, OUTSW, and OUTSD are synonyms for the byte, word, and doubleword OUTS instructions. OUTS can be preceded by the REP prefix for block output of CX bytes or words. Refer to the REP instruction for details on this operation. Flags AffectedNoneProtected Mode Exceptions#GP(0) if CPL is greater than IOPL and any of the corresponding I/O permission bits in TSS equals 1; #GP(0) for an illegal memory operand effective address in the CS, DS, or ES segments; #SS(0) for an illegal address in the SS segment; #PF(fault-code) for a page faultReal Address Mode ExceptionsInterrupt 13 if any part of the operand would lie outside of the effective address space from 0 to 0FFFFHVirtual 8086 Mode Exceptions#GP(0) fault if any of the corresponding I/O permission bits in TSS equals 1; #PF(fault-code) for a page fault
[Home Page dell'ITIS "Fermi"] [80386 Programmer's Reference Manual Index] [Previous] [Next] |